ruby – 选择GPIO监控

我正在尝试监视GPIO引脚,根据Linux文档,我应该能够通过使用select监视/ sys / class / gpio / gpio ## / value文件来完成此操作:

"value" ... reads as either 0 (low) or 1 (high).  If the GPIO
    is configured as an output,this value may be written;
    any nonzero value is treated as high.

    If the pin can be configured as interrupt-generating interrupt
    and if it has been configured to generate interrupts (see the
    description of "edge"),you can poll(2) on that file and
    poll(2) will return whenever the interrupt was triggered. If
    you use poll(2),set the events POLLPRI and POLLERR. If you
    use select(2),set the file descriptor in exceptfds. After
    poll(2) returns,either lseek(2) to the beginning of the sysfs
    file and read the new value or close the file and re-open it

我试图在Ruby中执行此操作,并且根据IO.Select documentation调用select(2).

所以,凭借这些知识,我将以下测试程序汇集在一起​​:

fd = File.open("/sys/class/gpio/gpio17/value","r")

loop do
  rs,ws,es = IO.select(nil,nil,[fd],5)
  if es
    r = es[0]
    puts r.read(1)
  else
    puts "timeout"
  end
end

但是,它没有检测到任何引脚变化.当我启动这个应用程序时,它将立即进入if块并显示引脚的当前值,然后每5秒打印一次超时.

我读错了文档吗?不应该选择能够监控吗?

最佳答案
在选择将在GPIO引脚上正确触发之前,您需要设置引脚的边沿触发.从the GPIO docs开始:

"edge" ... reads as either "none","rising","falling",or
    "both". Write these strings to select the signal edge(s)
    that will make poll(2) on the "value" file return.

    This file exists only if the pin can be configured as an
    interrupt generating input pin.

在Ruby中简单地说:

File.open("/sys/class/gpio/gpio17/edge","w") { |f| f.write("both") }

上面的完整示例如下所示:

fd = File.open("/sys/class/gpio/gpio17/value","r")
File.open("/sys/class/gpio/gpio17/edge","w") { |f| f.write("both") }

loop do
  rs,5)
  if es
    r = es[0]
    puts r.read(1)
  else
    puts "timeout"
  end
end

相关文章

文章浏览阅读1.8k次,点赞63次,收藏54次。Linux下的目录权限...
文章浏览阅读1.6k次,点赞44次,收藏38次。关于Qt的安装、Wi...
本文介绍了使用shell脚本编写一个 Hello
文章浏览阅读1.5k次,点赞37次,收藏43次。【Linux】初识Lin...
文章浏览阅读3k次,点赞34次,收藏156次。Linux超详细笔记,...
文章浏览阅读6.8k次,点赞109次,收藏114次。【Linux】 Open...